Cloverleaf Pond Heater 2kW

£185.00

Cloverleaf Pond Heater 2kW (with Thermo Control)

  • Max pond size 9000L
  • Cable length 1.5m
  • Min flow rate 9000lph
  • Couplings and hose tails supplied to allow connection to 38mm rigid pipe or 19mm – 38mm semi rigid pipe
  • Adjustable temperature control
  • Safety flow switch
  • Dimensions L:23cm x W:18.5cm x H:18.5cm
  • Weight 1.2kg
SKU: HE851 Category: Tag:

Description

Cloverleaf Pond Heater 2kW (with Thermo Control)

Models Available: 1kw, 2kw All fittings, threads and hose sizes are identical making them interchangeable.

We suggest that, on average, 1kw of power is suitable per 1000 gals (4450ltrs) of pond water in most instances.

These new models are compact and easy to use both models are supplied with couplings and hose tails to connect to either rigid 1.5″ pipe or 3/4″ to 1.5″ semi rigid pipe, it is recommended to use the largest size pipe feed your pump will allow to make sure of sufficient pressure to operate the internal flow switch. Temperature is controlled by adjusting a dial to the required temperature setting. A minimum water flow of 4000 Liters an hour is required at the heater to operate the built in safety flow switch which in the event of the pump stopping shuts the heater off to prevent damage to the heater.

Additional helpful installation information.

For maximum efficiency and to maintain an ambient temperature the pond should be covered and insulated to help achieve and maintain the pond temperature in cases of insufficient insulation more KW per gal/litre may be required depending on the level of desired water temperature. it is suggested to use a maximum pump delivery of 6000Liters an hour to maximize efficiency, unlike a conventional water heater pond heaters gradually heat the water on each pass so running too fast is less efficient, it will take several hours to reach the required set temperature when first used, if the pond is insufficiently insulated it may not be possible to achieve the desired set temperature or maintain a stable water temperature.

These heaters are designed to be pump fed and will not work on a gravity return.

The Heater should ideally be installed at the end of the water return to the pond after Ultraviolet steriliser’s and filters such as all in one pressure filters to reduce excessive water back pressure in the heater, the maximum working pressure is 0.3mpa and should not be exceeded as this may lead to water ingress into the electric’s of the unit voiding the warranty in the case of failure due to water damage.

Additional information

Weight 1.2 kg
Dimensions 23 × 18.5 × 18.5 cm

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top
Our latest offers